Dell EMC PowerEdge R940xa, Инструкция по установке и обслуживанию, Страница: 169 / 177

System health and system ID indicator codes
The system health and system ID indicator is located on the left control panel of your system.
Figure 118. System health and system ID indicators
Table 46. System health and system ID indicator codes
Indicator code Description
Solid blue Indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health
and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID button to switch to system health
mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem persists, see the Getting help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log or the LCD panel, if available on the
bezel, for specific error messages. For information about the event and error messages generated by the system
firmware and agents that monitor system components, see the Error Code Lookup page at
qrl.dell.com .
iDRAC Quick Sync 2 indicator codes
iDRAC Quick Sync 2 module (optional) is located on the left control panel of your system.
Figure 119. iDRAC Quick Sync 2 indicators
Table 47. iDRAC Quick Sync 2 indicators and descriptions
Indicator code Description Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC Quick
Sync 2 button to turn on the iDRAC Quick
Sync 2 feature.
If the LED fails to turn on, reseat the left control panel flex cable and
check. If the problem persists, see the
Getting help section.
Solid white Indicates that iDRAC Quick Sync 2 is ready
to communicate. Press the iDRAC Quick
Sync 2 button to turn off. If the LED fails to turn off, restart the system. If the problem
persists, see the
Getting help section.
Blinks white
rapidly Indicates data transfer activity.
If the indicator continues to blink indefinitely, see the Getting help
section.
Blinks white slowly Indicates that firmware update is in progress. If the indicator continues to blink indefinitely, see the
Getting help
section.
Blinks white five
times rapidly and
then turns off Indicates that the iDRAC Quick Sync 2
feature is disabled. Check if iDRAC Quick Sync 2 feature is configured to be disabled by
iDRAC. If the problem persists, see the
Getting help section. For
more information, see Integrated Dell Remote Access Controller
User's Guide at www.dell.com/idracmanuals or Dell OpenManage
Server Administrator User’s Guide at www.dell.com/
openmanagemanuals .
System diagnostics and indicator codes 169