Dell EMC PowerEdge R7525, Инструкция по установке и обслуживанию, Страница: 175 / 209

NOTE: All GPU/FPGA cards require L-type heat sink and GPU shroud, irrespective of the length.
3. Remove the air shroud and install the GPU air shroud .
4. Remove the GPU air shroud top cover .
NOTE: The GPU air shroud top cover is part of the GPU air shroud.
5. Install the GPU .
Refer to the riser and GPU slot configuration table to know about the slots for the GPU installation.
Table 54. Riser and GPU slot configuration
Riser Riser slots Processor System riser
configuration
Riser/card type GPU slots
Riser 1 Slot 1 Processor 1 Configuration 3 R1A - FH/FL or HL 2
Slot 2 Processor 1 Configuration 6 R1C - FH/HL 1, 2
Riser 2 Slot 3 Processor 1 Configuration 3 or 6 R2A - HH/HL 3, 6
Slot 6 Processor 2
Riser 3 Slot 5 Processor 2 Configuration 3 R3A - FH/FL or HL 5
Configuration 6 R3A - FH/HL
Riser 4 Slot 7 Processor 2 Configuration 3 R4A - FH/FL or HL 7
Slot 8 Configuration 6 R4C - FH/HL 7, 8
FH - Full Height, FL - Full Length, HH - Half Height, HL - Half Length
NOTE: For information on riser slot location on the system board, see the System board jumpers and connectors
topic.
6. If applicable, connect the power cables to the GPU. To know the connectors for GPU on the system board, see the System board
jumpers and connectors topic.
Refer to the GPU power cable matrix to know about the requirement of cable for the GPU.
Table 55. GPU power cable matrix
Category Description Type Vendor Cable Cable quantity
GPU CRD,GRPHC,NVIDIA,T
4,16GB,70W,L HH and HL NVIDIA Not required Not required
GPU CRD,GRPHC,32GB,22
5W,M10,PASSIV FH and FL NVIDIA 6 + 2 pin cable 1 piece per GPU riser
GPU CRD,GRPHC,16GB,25
0W,V100,FF3.0 FH and FL NVIDIA 8 pin cable 1 piece per GPU riser
GPU CRD,GRPHC,32GB,25
0W,V100S,PCIE FH and FL NVIDIA 8 pin cable 1 piece per GPU riser
GPU CRD,GRPHC,NVIDIA,2
4GB,RTX6000 FH and FL NVIDIA 8 pin cable 1 piece per GPU riser
GPU CRD,GRPHC,NVIDIA,4
8GB,RTX8000 FH and FL NVIDIA 8 pin cable 1 piece per GPU riser
FPGA Xilinx Snow White
Card FH and FL Xilinx 6 + 2 pin cable 1 piece per GPU riser
HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length
NOTE: Maximum of three full length GPUs with power cables or a maximum of six half lengths GPUs are supported
in a system.
7. To connect the XGMI cable,
a. Connect the MB_SL1 and MB_SL2 connectors on the XGMI cable to the J_SL1 and J_SL2 connectors on the system board.
Upgrade Kits 175