Figure 102. Installing GPU on Riser 3 and Riser 4
Next steps
1. If removed,
.
2.
Install the GPU air shroud top cover
3.
Install the full length expansion card riser
4. Follow the procedure listed in
After working inside your system
5. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
on page 47.
3.
.
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
144
Installing and removing system components
Содержание PowerEdge R7525
Страница 25: ...Figure 14 Service information System overview 25 ...
Страница 79: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 79 ...
Страница 80: ...Figure 55 16 x 2 5 inch Figure 56 24 x 2 5 inch with NVMe 80 Installing and removing system components ...