Next steps
1. If removed,
.
2.
Install the GPU air shroud top cover
3. Follow the procedure listed in
After working inside your system
4. Install any device drivers required for the card as described in the documentation for the card.
Removing a GPU
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
on page 47.
3. If applicable, disconnect the cables from the expansion card.
4.
Remove the GPU air shroud top cover
5.
Remove the full length expansion card riser
.
Steps
1. Open the expansion-card latch, and remove the metal filler bracket away from the riser.
Figure 97. Removing the metal filler bracket
2. To remove the GPU from Riser 1:
a. Disconnect the GPU power cable from the GPU card.
b. Press the button, and pull the black card holder before removing the GPU card from the riser.
c. Open the expansion card holder latch on the riser.
d. Hold the GPU card by the edges and pull the card until the card edge connector disengages from the GPU card connector on the
riser.
Installing and removing system components
139
Содержание PowerEdge R7525
Страница 25: ...Figure 14 Service information System overview 25 ...
Страница 79: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 79 ...
Страница 80: ...Figure 55 16 x 2 5 inch Figure 56 24 x 2 5 inch with NVMe 80 Installing and removing system components ...