Figure 102. Installing optional IDSDM/vFlash card
Next steps
1
.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2
If applicable, install the full height PCIe card.
3
Follow the procedure listed in
After working inside your system
.
Network daughter card
Removing the network daughter card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
If applicable,
remove the expansion card riser 2
.
Steps
1
Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2
Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3
Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Installing and removing system components
149
Содержание PowerEdge R740
