Ports and connectors specifications
USB ports specifications
Table 59. PowerEdge R6525 system USB specifications
Front
Rear
Internal
USB port type
No. of ports
USB port type
No. of ports
USB port type
No. of ports
USB 2.0-compliant
port
One
USB 3.0-compliant
ports
One
Internal USB 3.0-
compliant port
One
Micro-USB 2.0
compliant port
One
USB 2.0-compliant
ports
One
NOTE:
The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
NIC port specifications
The PowerEdge R6525 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on the LAN
on Motherboard (LOM) and integrated on the optional OCP cards.
Table 60. NIC port specification
Feature
Specifications
LOM card
1 GB x 2
OCP card (OCP 3.0)
1 GbE x 4, 10 GbE x 2, 25 GbE x 2, 25 GbE x 4, 50 GbE x 2, 100
GbE x 2
Serial connector specifications
The PowerEdge R6525 system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal Equipment
(DTE), 16550-compliant.
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R6525 system supports one DB-15 VGA port that is located on the front and rear panel of the system.
IDSDM
The PowerEdge R6525 system supports optional Internal Dual SD module (IDSDM).
The IDSDM supports two SD cards and is available in the following configurations:
Table 61. Supported SD card storage capacity
IDSDM card
•
16 GB
•
32 GB
•
64 GB
NOTE:
One IDSDM card slot is dedicated for redundancy.
Technical specifications
129
