Figure 39. Installing the M.2 SSD module
1
module connector (2)
2
screws (2)
3
modules (2)
Next steps
1
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2
3
Follow the procedure listed in
After working inside your system
.
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
.
Steps
1
Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION:
To prevent damage to the NDC, you must hold the card only by its edges.
2
Lift the card from the system board.
82
Installing and removing system components