Figure 23. Installing the SD vFlash card
1
SD vFlash slot
2
SD vFlash card
Next steps
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
After working inside your system
Replacing the SD vFlash card
LAN on Motherboard (LOM) riser card
The LOM riser card installed in your system is an integrated network interface controller. You can remove and install the LOM riser card.
Removing the LOM riser card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
Keep the Phillips #2 screwdriver ready.
Steps
1
Remove the two screws that secure the LOM riser card to the system board.
2
Lift the card from the system board.
74
Installing and removing sled components