Figure 14. Installing the memory module
1
memory module
2
alignment key
3
memory module socket ejector (2)
Next steps
1
Install the cooling shroud.
2
Follow the procedure listed in the After working inside your system section.
3
Press F2 to enter System Setup, and check the
System Memory
setting.
The system should have already changed the value to reflect the installed memory.
4
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
5
Run the system memory test in system diagnostics.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Installing the cooling shroud
After working inside your system
Removing memory modules
PCIe mezzanine card
The sled supports one x8 PCIe Gen3 mezzanine card. The PCIe card provides an interface between the sled and external storage devices.
NOTE:
Ensure that the PCIe mezzanine card is set to Enabled in System Setup.
NOTE:
The PCIe mezzanine card slot is available for use only when CPU2 is installed.
62
Installing and removing sled components
