Next steps
1
.
2
Follow the procedure listed in
After working inside your system
.
Graphics processing unit
NOTE:
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
PowerEdge C4140 supports two form factors of GPUs:
•
Up to four PCIe GPUs supported with the GPU switch board or system board.
•
Four SXM2 GPUs supported with the NVLink board.
PCIe Graphics processing unit
NOTE:
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
The following are the high-level steps that you must perform to replace the PCIe GPUs:
1
Remove the GPU blank.
2
Remove the GPU riser cable from the system board.
3
Remove the GPU.
4
Remove the GPU riser cable board.
5
Remove the custom GPU brackets from the GPU removed from your system.
6
Remove the GPU brackets from the replacement GPU.
7
Remove the optional GPU switch board.
8
Install the optional GPU switch board.
9
Install the GPU brackets on the GPU removed from your system.
10
Install the custom GPU brackets on the replacement GPU.
11
Install the GPU riser cable board.
12
Install the GPU blank.
13
Install the GPU.
14
Install the GPU riser cable on the system board.
GPU installation guidelines
•
The processor must be of 150 W or less.
•
Due to the high power consumption of GPUs, the ambient system inlet temperature is restricted to 25°C to ensure adequate system
cooling when one or more GPU cards are installed.
NOTE:
Certain system configurations may require reduction in the maximum ambient system inlet temperature limit. The
performance of the system may be impacted when operating above the maximum temperature limit or with a faulty fan.
•
All GPUs must be of the same type and model.
•
You can install up to four GPUs.
NOTE:
Incorrect removal and installation of the GPUs will cause operational issues to your system.
Installing and removing system components
97