Figure 15. Removing the intrusion switch
Installing the intrusion switch
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE:
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
Steps
1
Insert the intrusion switch into the intrusion switch slot.
2
Slide the intrusion switch until it locks into position.
3
Connect the intrusion switch cable to the connector on the system board.
Installing and removing system components
59