5
Disconnect the expansion card riser cable from the NVLink board.
Steps
1
Loosen the thumbscrews that secure the NVLink board to the chassis.
2
Hold the NVLink board by the board holder, and slide the NVLink board towards the system fan to release it from the chassis.
3
Lift and remove the NVLink board out of the chassis.
Figure 74. Removing the NVLink board
Next step
1
Install the NVLink board.
Installing the NVLink Board
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE:
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
1
Follow the safety guidelines listed in
Steps
1
Hold the board holders and lower the NVLink board into the chassis at an angle. Slide it to engage the slots on the NVLink board tray
with the guide pins on the front inner wall of the chassis.
2
Tighten the thumbscrews to secure the NVLink board to the chassis.
118
Installing and removing system components