Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
1. Replace the speaker into the slot in the computer.
2. Route the speaker cable along the cable guides on the palmrest assembly.
NOTE:
While replacing the speakers, route the speaker cable into the routing channels along the bottom side of the
palmrest assembly.
Connect the main speaker cable to the
SPK.MAIN
connector on the speaker board and route the speaker cable over the
tweeter speaker cable.
Next steps
1. Install the
.
2. Install the
.
3. Install the
after working inside your computer
.
46
Removing and installing components
Содержание Latitude 7520
