NOTE:
Ensure that the drive carrier's release handle is in the open position before inserting the carrier into the slot.
1. Follow the safety guidelines listed in the
on page 26.
2. If installed,
.
3. Remove the drive carrier or remove the drive blank when you want to assemble the drives in to the system.
Steps
1. Slide the drive carrier into the drive slot.
2. Close the drive carrier release handle to lock the drive in place.
Figure 43. Installing a drive carrier
Next steps
.
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. If installed,
.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
52
Installing and removing system components
Содержание E68S
Страница 19: ...Figure 14 Service information System overview 19 ...
Страница 59: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 59 ...
Страница 61: ...Figure 57 24 x 2 5 inch with NVMe Figure 58 16 x 2 5 inch Installing and removing system components 61 ...
Страница 62: ...Figure 59 8 x 2 5 inch with NVMe Figure 60 8 x 2 5 inch with NVMe 62 Installing and removing system components ...
