Removing the full length expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in the
Before working inside your system
3.
Remove the GPU air shroud top cover
.
Steps
1. To remove expansion card Riser 1A:
a. Loosen the captive screws on the riser.
b. Press the blue release tab and holding the edges lift the expansion card riser from the riser connector on the system
board.
c. Disconnect the GPU power cable from the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 94. Removing the expansion card riser (Riser 1A)
2. To remove expansion card Riser 3A:
a. Press the blue button on the riser, and holding the touch points lift the expansion card riser from the riser connector on
the system board.
b. Disconnect the GPU power cable from the system board.
Installing and removing system components
119
Содержание E68S
Страница 19: ...Figure 14 Service information System overview 19 ...
Страница 59: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 59 ...
Страница 61: ...Figure 57 24 x 2 5 inch with NVMe Figure 58 16 x 2 5 inch Installing and removing system components 61 ...
Страница 62: ...Figure 59 8 x 2 5 inch with NVMe Figure 60 8 x 2 5 inch with NVMe 62 Installing and removing system components ...
