Dell EMC E67S, Инструкция по установке и обслуживанию

Страница: 13 / 149

NOTE: For more information about the ports, see the www.dell.com/poweredgemanuals section.
Rear view of the system
Figure 7. Rear view of the 10 x 2.5-inch drive system
Table 6. Rear view of the system
Item Ports, panels, or slots Icon Description
1 Power supply unit (PSU 1) For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals section.
2
PCIe expansion card riser
(slot 1) N/A
The expansion card riser enables you to connect PCI
Express expansion cards. For more information about the
expansion cards that are supported on your system, see
www.dell.com/poweredgemanuals section.
3 PCIe expansion card riser
(slot 2) N/A
The expansion card riser enables you to connect PCI
Express expansion cards. For more information about the
expansion cards that are supported on your system, see
www.dell.com/poweredgemanuals section.
4 USB 2.0 port (1) This port is USB 2.0-compliant.
5 Power supply unit (PSU
2) For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals section.
6
VGA port Enables you to connect a display device to the system. For
more information, see the
www.dell.com/
poweredgemanuals section.
7 USB 3.0 port (1) This port is USB 3.0-compliant.
8 iDRAC dedicated port
Enables you to remotely access iDRAC. For more
information, see the iDRAC User’s Guide at
www.dell.com/
poweredgemanuals .
9 System identification
button Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
●
To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press
and hold the system ID button (for more than 5
seconds) to enter the BIOS progress mode.
System overview 13