Dell EMC E67S, Инструкция по установке и обслуживанию

Страница: 129 / 149

Figure 126. Installing the BOSS blank
To install the BOSS S2 controller card module:
1. Install the BOSS S2 controller card module. To install the BOSS S2 controller card module, see installing the BOSS S2
controller card module steps 1 to 3.
2. Install the M.2 SSD. To install the M.2 SSD, see installing the BOSS S2 controller card module steps 4 to 8.
NOTE: Installing the BOSS S2 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS S2 controller card module.
NOTE: Connect the BOSS signal cable and BOSS power cable after inserting the BOSS S2 controller card module into the
system.
To remove the BOSS S2 controller card module:
1. Remove the M.2 SSD. To remove the M.2 SSD, see removing the BOSS S2 controller card module step 1 to 4.
2. Remove the BOSS S2 controller card module. To remove the BOSS S2 controller card module, see removing the BOSS S2
controller card module step 5 to 6.
3. Install the BOSS blank.
NOTE: Removal of the BOSS S2 card carrier does not require the system to be powered off. System shutdown is only
required when removing the BOSS S2 controller card module.
NOTE: Disconnect the BOSS signal cable and the BOSS power cable before lifting the controller card module from the
system.
PCIe Gen 4 NVMe enablement Kit
NOTE: To enable the PCIe Gen4 NVMe feature, update the BIOS version to 1.2.11 or greater and backplane firmware
version to be greater than 2.84 . For latest firmware, refer to the System’s Drivers and Downloads page at www.dell.com/
support/drives and search for PowerEdge R6525.
Upgrade Kits 129