NOTE:
It is normal for the heat sink to slip off the blue retention clips when the screws are partially loosened, continue
to loosen the screw(s).
2
Pushing both retention clips simultaneously, lift the Processor and heat sink module (PHM) out of the system.
3
Set the PHM aside with the processor side facing up.
Figure 29. Removing the processor and heat sink module
Next step
1
Removing the processor from the processor and heat sink
module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to
cool before removing it.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
.
4
Remove the processor and heat sink module
Steps
1
Insert a flat blade screwdriver into the release slot marked with a yellow label. Rotate (do not pry) the screwdriver to break the thermal
paste seal.
2
Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Installing and removing system components
73
