Install and secure the server in the cabinet (sliding rails)
This procedure is used to install the server (mounted on sliding rails) in the cabinet.
CAUTION
The server is heavy and should be installed in a cabinet by two people. To avoid
personal injury and/or damage to the equipment, do not attempt to install the
server in a cabinet without a mechanical lift and/or help from another person.
Procedure
1. At front of the cabinet, pull the inner slide rails out of the rack until they lock
into place (1). Locate the rear rail standoff on each side of the server and lower
them into the rear J-slots on the slide assemblies (2). Rotate the system
downward until all the rail standoffs are seated in the J-slots (3). Push the
server inward until the lock levers click into place. Press the slide-release lock
buttons on both rails and slide the system into the rack (4).
Figure 12 Installing the server on the rails
2. Push the server into the cabinet. The latches (1) engage automatically as the
system is pushed into the cabinet.
Dell PowerEdge R630 Server FRUs
DELL EMC CONFIDENTIAL
Install and secure the server in the cabinet (sliding rails)
55