Dell EMC 6WDJR, Инструкция по установке и обслуживанию

Страница: 75 / 129

Replacing the optional internal USB memory key
Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1 Follow the safety guidelines listed in the Safety instructions .
2 Follow the procedure listed in the Before working inside your system .
3 Remove the expansion card riser .
Steps
1 Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
System board jumpers and connectors section.
2 If installed, remove the USB memory key from the USB port.
3 Insert the replacement USB memory key into the USB port.
Next steps
1 Replace the expansion card riser .
2 Follow the procedure that is listed in After working inside your system .
3 While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional optical drive
Removing the optical drive
The procedure for removing an optical drive and optical drive blank is the same.
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions .
2 Follow the procedure listed in the Before working inside your system .
NOTE: Observe the routing of the cable as you remove it from the system.
Steps
1 Disconnect the power and signal cables from the optical drive.
2 To release the optical drive, press the release tab and push the drive towards the front of the system.
3 Slide the optical drive out of the system.
Installing and removing system components 75