Footrest Clamp
FIG. 9
Footrest Hook
Footrest
Adjusting
Screws
To adjust the footrest height;
first remove the footrest (see
page 8). Loosen the footrest
adjusting screws with a 5mm
hexagon key (see fig. 9) and slide
the footrest clamps up or down
the frame tubes to the desired
height.
Adjust the position of the clamps
so that they are at equal heights
and the footrest hooks are in line
with the frame.
Tighten the screws and check that
the footrest fits securely. There
should be less than 1mm clearance
between the brackets on the
footrest and the footrest hooks
(see fig.23 on page 21).
The foot-straps are designed to be
long enough to remain under the
loops on the footrest while
positioning the foot.
To attach the sun-hood; with the sun-hood
f
olded
, fit the back of the hood
over the top of the backrest. Carefully insert the ends of the wire frame into the
holes in the handle bracket and push them in as far as they go. Hook the ends of the
bungee cords onto the slot in the rear frame bracket.
Pg
.10
Attach bungee to slot in
frame bracket.
Frame of hood fits into
holes in handle bracket.
FIG. 10
