31
You don
‟t need to add all MAC address of devices existing in your network to the WDS AP List. The WDS AP List only
needs to specify the MAC address of devices you need to directly connect to.
The bandwidth of the device is limited. Bandwidth will be shared between bridging devices.
WDS Network Topology
In this section, we will demonstrate the WDS network topologies and WDS AP List configuration. You can setup four kinds of
network topologies: bus, star, ring and mesh.
In this case, there are five devices with WDS enabled: WDS1, WDS2, WDS3, WDS4 and WDS5.
Bus topology
Device
Entries of WDS AP List
Spanning Tree Protocol
Required
WDS1
The MAC Address of WDS2
No
WDS2
The MAC Addresses of WDS1 and WDS3
No
WDS3
The MAC Addresses of WDS2 and WDS4
No
WDS4
The MAC Addresses of WDS3 and WDS5
No
WDS5
The MAC Address of WDS4
No
Star topology
Device
Entries of WDS AP List
Spanning Tree
Protocol Required
WDS1
The MAC Addresses of WDS2, WDS3, WDS4 and
WDS5
No
WDS2
The MAC Address of WDS1
No
WDS3
The MAC Address of WDS1
No
Содержание DBL2119
