Milk, Ice Cream & Milk & Ice Cream Dispensers Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
4
Milk, Ice Cream & Milk & Ice Cream Dispensers Service and Installation Manual
5
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
How to adjust self-leveling dispenser
Tools Needed:
One small flat head screw driver; One Phillips
head screw driver.
1.
Always wear safety glasses when adjusting your dispenser.
Also, lock brakes on mobile units before beginning.
2.
Unload dispenser and remove stainless steel load tray by
lifting straight up and set it aside (see fig. 1).
3.
Use small regular screw driver to loosen each retainer
mounted on stainless steel rod at top of each elevator
housing.
4.
To remove
elevator housing,
lift housing
straight up to
clear the stud on
unit base. Then
gently swing the
bottom of the
housing towards
the inside of the
unit and pull
housing out of
the unit (see fig.
2). Lay housing
on flat surface.
5.
Use Phillips head
screw driver to
remove front panel
on the elevator
housing (see fig. 3).
6.
If carrier is riding
too high, you need
to remove springs.
With carrier all the
way to the top,
gently disengage
one spring at a
time, unhooking
bottom loop out of
carrier bracket (see
fig. 4). Remove as
many springs as
necessary.
If carrier is riding too
low, you need to add
springs. With carrier
all the way to the top,
gently engage one
spring at a time by
hooking bottom loop
of spring into carrier
bracket. Add as many
springs as necessary.
7.
When finished, put elevator housing back in unit and put
stainless steel load tray back on elevator housings. Load
unit to test dispensing level. If spring adjustment does
not position carrier properly, repeat procedure #6 trying
different springs. If this does not work, a different set
of springs may be required. To order, call The Delfield
Company Parts and Service Department at 800.733.8829
8.
If level is appropriate, put front panels back on and
tighten retainer.
CAUTION: Dispenser should not be operated
with front panels off elevator housing.
NOTE:
When adjusting the elevators make sure each have the
same number and size of springs connected to the carrier on
both sides. This will prevent the load tray from binding.
RETAINER
LOAD TRAY
ELEVATOR HOUSINGS
RETAINER
(figure 1) Sample unit
(figure 2) Remove elevator housing
REMOVE SCREWS,
SLIDE COVER OFF
(figure 3) Remove front panel
REMOVE OR
ADD SPRINGS
AS NEEDED
(figure 4) Remove or add springs
INSTALLATION CONTINUED