Milk, Ice Cream & Milk & Ice Cream Dispensers Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
4
Milk, Ice Cream & Milk & Ice Cream Dispensers Service and Installation Manual
5
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
Location
Be sure the location chosen has a floor strong enough to
support the total weight of the cabinet and contents. Units in
this product line can weigh as much as 1500 pounds when it
is fully stocked. Reinforce the floor as necessary to provide for
maximum loading.
For the most efficient refrigeration, be sure to provide good air
circulation inside and out.
Inside cabinet:
Do not pack unit so full that air cannot circulate.
Take care not to block air flow to the fans and allow space
along sides.
Outside cabinet:
Be sure that the unit has access to ample
air. Avoid hot corners and locations near stoves and ovens.
It is recommended that the rear of the unit be no less than
two inches from any wall, partition or any other object which
will restrict exhaust air flow.
Leveling
A level cabinet looks better and will perform better because
the cabinet will not be subject to unnecessary strain due to
doors not properly lining up with door frames.
Some models have casters for ease of cleaning underneath
and for mobility. It is important that the unit be installed in a
stable condition with the front casters locked before operating.
Locking the front casters after installation is the owner’s and
operator’s responsibility.
Electrical connection
A standard self-contained unit is provided with a power cord
and three-prong grounded plug.
The unit should be plugged into a receptacle with its own
circuit protection that matches the amperage of the plug.
Refer to the amperage data on page three or the
serial tag data and your local code or the National
Electrical Code to be sure the unit is connected
to the proper power source. A protected circuit of
the correct voltage and amperage must be run for
connection to the unit.
The power supply must be disconnected
whenever performing maintenance or repairing
the equipment!
The unit must never be operated without the
louvered panel in place.
Built-in units
All self-contained units (MFSC, FFSC and RFFSC) are tested
at the factory to assure proper operation. The unit should not
be installed directly next to high heat generating equipment
(ranges, griddles, etc.).
These units are built into the counter from below and must
be supported from the bottom. The counter cut-out sizes and
power supply requirements are shown in the specifications on
page three. All refrigerators have drains located in the bottom
of the tank. An appropriate drainage area or container must
be provided by the customer. Be sure to place the unit so the
pressure control, located near the compressor, can be reached.
For installation of remote units (MF ,FF and RFF), consult a
refrigeration service company to connect refrigeration lines to
the remote condensing unit.
Self-contained refrigerated units (MFSC, FFSC
and RFFSC) require air flow to the compressor.
A louver is provided and must be installed in the
counter in front of the condenser. An equal size
opening at the rear of the cabinet must also be
provided to allow warm air to escape. Failure to
do so will void all product warranties.
Free standing units
All self-contained units (N, N6/10/14, NDF, NLFAC, SCF and
NSCF) are tested at the factory to assure proper operation. The
unit should not be installed directly next to high heat generating
equipment (ranges, griddles, etc.).
These units are free standing, either on legs or casters. The
power supply requirements are shown on page three. All free
standing units have drains located in the bottom of the tank.
An appropriate drainage area or container must be provided by
the customer.
Do not place the unit against a wall or any object that will
block air circulation through the condensing unit. If the unit
must be placed against a wall, leave a minimum of 2” of
space for air flow.
INSTALLATION