Delem DA-56, Справочное руководство

Страница: 96 / 126

V0505, 7.6
then the following parameters are automatically recomputed and changed by the control:
- Pressure
- Decompression distance
- Crowning device setting
2. In case you change the value of the parameter ‘length’ then the following parameters
are automatically recomputed and changed by the control:
- Pressure
- Decompression distance
- Crowning device setting
- Z-axis position
3. In case you change the parameter ‘punch’ or ‘die’ and the height of the new punch or
new die is different AND ONLY in case the ‘bend method’ is ‘bottoming’ or ‘flattening’
then the following parameter is automatically recomputed and changed by the control:
- Y-axis position (‘bend position’)
(When the ‘bend method’ is ‘air bend’ (normal situation) the Y-axis position is calcu-
lated in the automatic mode!)
If the automatic recomputation is switched off (default situation) then these parameters
stay the same. However, when you go to these parameters with the cursor keys the
recomputed value is displayed in the input row. When you press ‘enter’ the recomputed
value replaces the old value after all. So, you can choose to change the values.
X1X2 difference programming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XX =
0 = angular format
1 = projection method
When you have two independent X-axes (X1 and X2) and the option OP-X1X2 has been
installed, you can program the values for X1, X2 in a certain relation. This means that
you program X1 and an angle value (angular method) or in a projection measure.
Please ask the option description from your supplier when this option has been installed.
Only available when this option is installed.
Y opening default . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 =
Default Y-axis opening value.
The value programmed here is used as initial value for the parameter ‘Y-axis opening’ in
the Data Preparation menu of the programming mode.
Pressing speed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PS =
Default pressing speed, used as initial value for the parameter ‘speed’ in a new program.
Default X-axis code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XC =
Default value for the parameter 'code' in a bend program. This parameter determines the
moment of step change in a bend program. Initially the code parameter is set to the value
programmed here during postprocessing and during programming.
The default value of this parameter = 2.
See chapter 'data preparation/data edit' for more information about the code parameter.
Default X time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XT =
During the postprocessing, the waiting time of the X-axis at step change is put to zero.
With this parameter you can preset a longer waiting time when needed for product han-