Delem DA-56, Справочное руководство

Страница: 101 / 126

Delem
V0505, 7.11
during production. The parallelism which can be programmed for each bending (Y2) is
only active below the clamping point. The parallelism below the clamping point is the
sum of the two parameters (Y2 + Par. offset).
Flattening opening . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . OP =
Depending on the construction of your machine you can program here an openings posi-
tion for your punch at which position you can put in your product to flatten the particular
bend. A second mute output will become active which can stop the beam depending on
the machine interfacing. See figure below. The opening position will also take 2x sheet
thickness into account.
7.i
Pressure correction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FF =
Percentage of calculated tonnages which actually controls the pressure valve.
Clamping correction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CC =
The position of the beam at which the plate is clamped, is calculated. In order to have a
firm clamped plate it is possible to offset the calculated pinch point with the value here
programmed. A positive value will result in a deeper position, a negative value in a
higher position of the beam.
X-reference correction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XR =
When the actual, mechanical X-axis position is not corresponding with the displayed
value than is it possible to correct the position with this parameter. Program the calcu-
lated difference.
Example:
- When the programmed and displayed value = 250 and the actual, mechanical position
value = 252 the XR parameter = -2.
- When the programmed and displayed value = 250 and the actual, mechanical position
value = 248 the XR parameter = +2.
X2-reference correction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XR
Same function as the previous parameter but now for the X2-axis.
Intermediate X for Z-movement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XS=
Temporary safe value for the X-axis, to avoid collision as a result of movement along the
Z-axis. With this parameter a standard safety zone for the X-axis is defined, which is
valid for all programs. The value 0 disables this functionality. This parameter should not