Installation Manual
Festoon Systems for I-Beams
Program 0314
MAL0300-0001-EN
www.conductix.com
translated document
page 50 of 56
10.2
Dismantling
After the system is no longer in use, the festoon system must be disassembled and environmentally friendly disposal carried out.
Before starting disassembly:
Remove operating and auxiliary materials, as well as residual processing materials, and dispose of them in an environmentally
appropriate manner.
Then clean the assemblies and components properly and disassemble them as required by applicable local workplace safety and
environmental protection regulations.
Personnel:
May only be carried out by trained technicians
At least 2 people
Required tools:
Crescent wrench
Tools for securing
CAUTION!
Loads are to be carefully fastened onto suitable hoists or load-carrying devices that are technically
intact and have sufficient load capacity.
10.3
Disposal
In the absence of a return or disposal agreement, dismantled components must be recycled as follows:
Scrap metals.
Take plastic elements for recycling.
The other components are to be disposed of according to their material composition.
CAUTION!
Environmental damage due to improper disposal!
Electrical waste, electronic components, lubricants, and other auxiliary materials are subject to
hazardous waste disposal regulations and may only be disposed of by authorized specialists.
Local community officials or special disposal companies can provide information about environmentally appropriate disposal.
