Remote Management Unit: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
file:///T|/htdocs/stor-sys/124T/en/124tvs16/rmu.html[12/5/2012 10:26:00 AM]
7. Click
submit
to save the information.
Setting Network Options
When you originally installed the autoloader, you set the Ethernet configurations through the front LCD panel. However, you
can modify them through the Remote Management Unit. The options include
Current Network Parameters
,
Set IP
, and
Set Network Configuration
. To change the Ethernet configurations:
To view the
Current Network Parameters
:
1. From any page, click the
Configuration
heading. The
Configuration
screen displays.
2. From the
Configuration
menu, click
Networking
.
The
Current Network Parameters
area displays the current IP address, MAC address, and the speed setting for the
Ethernet connection.
In the
Set IP
section, if a check mark appears in the box next to
DHCP
, the dynamic IP address option is enabled. This
means that with every reset of the system, the IP address may change depending on the network administrator's settings.
To
Set IP
address:
1. Clear the check box to remove the check mark from the
DHCP
field, if applicable.
2. In the IP address fields, type the static IP address using the <Tab> key to move from box to box.
3. If no check mark appears in the box next to
DHCP
, the static IP address option is enabled. To change a static IP
address, type in the new address in the IP address fields using the <Tab> key to move from box to box.
4. To change the IP address from a static address to a dynamic address, click the box next to
DHCP
.
To
Set Network Configuration
:
1. To change the values of the subnet mask, gateway, Simple Network Management Protocol (SNMP) server, or the time
server, type in the new address, using the <Tab> key to move from box to box.
2. Click
submit
.
Setting Front Panel Security Options
When you enable the security option, users must enter a password to access the autoloader's front panel functionality. A
password allows either administrator-level access or operator-level access (see "
"). Up to two Admin and two
Operator passwords may be set. To set security:
1. From any page, click the
Configuration
heading. The
Configuration
screen displays.
2. On the left-hand side of the screen, click
Security
. The
System Security
section of the screen displays.
3. To enable front panel security, select the check box next to
Front Panel Security Enabled
.
If the check box is blank, the security option for the front LCD panel is not enabled.
4. Click
submit
.
To reset the front panel password:
1. From any page, click the
Configuration
heading. The
Configuration
screen displays.
2. On the left-hand side of the screen, click
Security
.
3. Select the check box next to
Reset Front Panel Password
. A check mark appears.
4. Click
submit
.
To set
User Administration
:
