Del Morino RES, Руководство по эксплуатации и обслуживанию

Страница: 7 / 39

7
ASSEMBLING INSTRUCTION
1.
A
STTACHING THE RES TO THE TRACTOR THREE POINT HITCH
a) Hook the machine to a crane using cables attached to the lifting points marked “Gancio“.
b) Lift and stabilize the machine at the level “H” (300 mm or 1 ft) from the ground and insert two blocks under
the base of the two stabilizers.
c) Back the tractor up to the machine, raise the three point hitch to the height of the machine connections and
connect the lower arms and the upper tie rod.
d) Install and adjust the bracket that will prevent the tractor hitch from moving.
2.
I
NSTALLING THE HYDRAULIC PUMP
e) Connect the pump unit with multiplier to the tractor PTO.
f) Use the locking device supplied with the machine to prevent the pump from rotating.
g) Verify the oil level inside the multiplier following the instruction on page 12, point a).
3.
A
LERNATIVE METHOD TO ATTACHING THE RES TO THE TRACTOR
h) Instead of using the two blocks (point b), it is possible to use the stabilizers of the machine to lift and stabilize
the machine at the height “H” (300 mm or 1 ft). In order to do this the hydraulic pump must first be connected
to the PTO.