3. Mounting
3.1 AGC 150 mounting and dimensions
3.1.1 Dimensions
157.9 mm (6.22 in)
173.3 mm (6.82 in)
217.9 mm (8.58 in)
233.3 mm (9.16 in)
44.7 mm
(1.76 in)
3.1.2 Tools and materials
Tools required for mounting
Tool
Used for
Safety equipment
Personal protection, according to local standards and
requirements
Screwdriver, PH2 or 5 mm flat
Tighten the fixing screw clamps, torque 0.15 N·m (1.3 lb-in)
Wire stripper, pliers and cutters
Prepare wiring and trim cable ties
CAUTION
Do not use power tools during the installation. Too much torque will damage the the screw clamps and/or the controller
housing.
Materials required for mounting and wiring
Materials
Used for
Four screw clamps
Mounting the controller in the front panel
Wires and connectors
Wiring third party equipment to the controller terminals
INSTALLATION INSTRUCTIONS UK
Page 7 of 22
