DEHACO DTS170 EU, Руководство пользователя

Страница: 10 / 16

10 Dehaco B.V. • Kruisbaak 25 • 2165 AJ Lisserbroek (NL) •
✆
+31 (0)88 - 20 20 600 •

info@dehaco.nl • www.dehaco.nl
9. Maintenance | 10. Malfunctions
10. MALFUNCTIONS
This section provides general guidelines for
troubleshooting at the machine, it is not a step-by-step
search diagram.
The Floor stripper DTS170 is solidly built and will
function free from failures for a long period of time, if
used carefully within the stated standards of use.
WARNING!
Only have electrical failures repaired by qualified
and skilled personnel and only use original
replacement parts.
FIRST:
- Disconnect all other machines from the same
power group.
- Try the machine without extension cords, near
the power supply.
10.1 Green led does not light up
Error in the power supply, check the following:
- Is the emergency stop button not pressed
down?
- Are the plugs inserted properly?
- Have any fuses blown? No fuse has been
included in the DTS170 itself.
- Is the extension cord not damaged / broken?
10.2 The driving components do not
function properly
- Has the cord for the tiller head been connected
(properly)?
- Check the power cord, does the led in the reset
button light up??
- Check the tiller head cord for damages.
- Check that the wheel motor is working.
§
Reset the frequency controller:
§
Pull the power cord out of the stripper.
§
Wait 30 seconds (=reset controller )
§
Place the power cord back in the counter
plug.
§
Restart the machine.
9. MAINTENANCE
WARNING!
Always first remove the plug from the socket before
performing inspection, maintenance or repairs!
The DTS170 Floor stripper is a simple, reliable
machine. Regularly maintenance is needed however,
to keep the machine in a good condition for optimum
results.
The indicated intervals are a guideline for normal use,
in case of more or less intensive use, these actions can
be performed more or less frequently!
The geared motor of the travel drive is maintenance
free!
9.1 Daily maintenance
- Regularly check the machine -visually- for leaks
and damages, this certainly also applies to the
power cord(s)!
- Repair damages immediately or have them
repaired. This also applies to minor damages.
This is for the benefit of your safety and the life
span of your machine.
- Remove all loose material from the stripper
mechanism.
- Keep the machine clean! This reduces the
risk of accidents and makes your work easier.
convenient!
- Lubricate the two eccentric bearings at the
front. One stroke with a grease gun with
Standard (EP2) grease is sufficient.
- Check that all bolts are properly fastened.
- Replace the bolts of the blade holder when the
heads show signs of wear.
CAUTION!
Clean carefully! Do not spray clean with a high-
pressure cleaner!
9.2 Torques
For 8.8 hexagon bolts, the following torques can be
observed. (Wurth):
M6x1,0-8.8 10 Nm.
M8x1,25-8.8 25 Nm.
M10x 1,5-8.8 50 Nm.