Degometal GO 3313, Руководство пользователя

Страница: 23 / 32

23
www.degometal.com
Nut does not rest against nosepiece (see Point 2.7.1)
While it is screwed on, hold the nut until
the tool stops
Nut
unscrews
again Keep
switch
K pressed until the tool stops
Battery
switched
off because it has been idle
for longer than 21 days
Place battery in the charger for 2 minutes (see 3.4)
Battery discharged
Charge battery, replace if necessary (see Point 3.3/3.4)
Set blind rivet nut is loose
Cause Corrective measures
Setting stroke y too short
Increase setting stroke y (see Point 2.7.2)
Switch
K released too early
Keep
switch
K pressed until automatic chan- geover and
unscrewing are finished (see
Point 2.7)
Threaded mandrel is not
unscrewed
Cause Corrective measures
Setting
stroke adjusted incorrectly
Decrease setting stroke y (see Point 2.7.2); if necessary
use hexagon screwdriver 8 to unscrew
threaded mandrel
A (see Fig. 1)
Battery discharged
Charge battery; replace if necessary
Red lamp indicates fault
When pressing the trigger button
Cause Corrective measures
Blind rivet nut setting tool not in front end position
Release trigger button
During pulling operation
Cause Corrective measures
Overload
Use tool
within working
range as specified in table (see 2.6.)
Electronics overheated
Allow
blind rivet nut setting tool to cool
down
in air
Battery discharged
Charge or replace
After releasing the trigger button
Cause Corrective measures
Front end position not reached
Screw
together mechanical parts
Caution!
If faults occur that are indicated by the red lamp and cannot be rectified as described above, have the blind
rivet nut setting tool repaired by a skilled technician or send it in to the manufacturer.
.
FR
ANCA
IS
EN
GLI
SH