Degometal GO 182, Руководство пользователя

Страница: 18 / 32

18
www.degometal.com
2. SECURITY
This instruction manual must be read with particular attention to the following safety
rules, by any person installing, operating, or servicing this tool.
1 Do not use outside the design intent.
2 Do not use equipment with this tool other than that recommended and supplied by tooI .
3 Any modification undertaken by the customer to the tool , nose assemblies, accessories or any
equipment supplied by tool or their representatives, shall be the customer's entire responsibility . We
will be pleased to advise upon any proposed modification .
4 The tool/machine must be maintained in a safe working condition at all times and examined at
regular intervals for damage and function by trained competent personnel. Any dismantling
procedure shall be undertaken only by personnel trained in tool procedures. Do not dismantle this
tool/machine without prior reference to the maintenance instructions . Please contact us with your
training requirements.
5 The tool/machine shall at all times be operated in accordance with relevant Health and
Safety legislation . Any question regarding the correct operation of the tool/machine and
operator safety should be directed to us.
6 The precautions to be observed when using this tool/machine must be explained by the customer
to all operators.
7 Always disconnect the airline from the tool/machine inlet before attempting to adjust, fit or remove a
nose assembly.
8 Do not operate a tool/machine that is directed towards any person(s) or the operator .
9 Al w ays adopt a firm footing or a stable position before operating the tool/machine .
10 Ensure that vent holes do not become blocked or covered .
11 The operating pressure shall not exceed 7 bar .
12
Do not operate the tool if it is not fitted with a complete nose assembly or swivel head unless
specifically instructed otherwise.
13
Care shall be taken to ensure that spent stems are not allowed to create a hazard.
14 If the tool is fitted w ith a stem collec tor , it must be emptied when half full .
15 If the tool is fitted with a stem deflector, it should be rotated until the aperture is facing way from
the operator and other person(s) working in the vicinity.
16 When using the tool, the wearing of safety glasses is required both by the operator and