24.03.2017
ASSEMBLY AND OPERATING MANUAL DEGERtracker D60H, D80, D100
Page 18
6 Assembly of the DEGERtracker
DANGER!
Danger to life caused by suspended loads!
If heavy parts swing out and fall down they can cause severe or even fatal injuries.
Never step under or into the slewing range of suspended loads.
Move loads only under supervision.
Use only lifting gear and lifting tackle of appropriate capacity for the weight of the component to
be lifted.
Do not use any cracked or torn lifting tackle, like ropes or belts.
Take care of eccentric centre of gravity.
Components may only be lifted by persons who are entitled to work with the required lifting gear.
At wind speeds in excess of 3 m/s all work must be stopped.
Wear hard hat, safety shoes and safety gloves.
DANGER!
Danger to life caused by uncontrolled moving parts!
If heavy parts swing out and fall down they can cause severe or even fatal injuries.
The tightening strap for fixing the toggle lever to the rotating head must only be removed after the
elevation drive has been assembled.
WARNING!
Danger of injury due to of improperly performed assembly work!
Improperly executed assembly work can lead to severe injuries and considerable material damage.
Ensure sufficient assembly space before starting work. Parts are up to 10.80 m long.
The base frame must be assembled on level ground.
Ensure correct assembly. Comply with all specified bolt tightening torques.
For work at heights in excess of 1 m appropriate safety precautions against falling down must be
applied. Use personal protective equipment to protect against falling down.
Wear hard hat, safety shoes and safety gloves.
WARNING!
Danger of injury by sharp edged parts!
When assembling the DEGERtracker, sharp edged parts can cause serious hand injuries.
Wear safety gloves.
DANGER
Danger of injury due to improperly performed assembly work!
Improperly executed assembly work can lead to severe injuries.
