DeDietrich SR 130, Руководство по установке

Страница: 3 / 20

3
29/05/06 - 300009755-001-H SR 130
Introduction
SR 130 domestic hot water calorifiers are connected to gas-fired
wall-hung boilers from the City 1.24 - 1.24FF - 3.24 and 3.24FF range
and to gas-fired wall-hung condensation boilers from the
DPSM3 15 LP - DPSM3 25 LP - MC 15 LP and MC 25 LP - MCR 24
range. For a proper operating of the boiler, follow carefully the
instructions.
1 Compliance
Compliance of design and manufacture
This product complies with the requirements of European Directive
97 / 23 / EC, Article 3, Paragraph 3, on pressure equipment.
Electrical compliance / Marking
1
This product complies to the requirements to the European Directives
and following standards:
• 73/23/EEC Low Voltage Directive
Reference Standard : EN 60.335.1.
• 89/336/EEC Electromagnetic Compatibility Directive
Reference Standards : EN 50.081.1 / EN 50.082.1 / EN 55.014.
2 Important recommendations
Positioning the appliance:
- in a frost-free room.
- on a base to facilitate cleaning the room.
- as close as possible to draw-off points in order to minimise energy
losses through the pipes.
Insulating the pipes.
Heating water and domestic water must not come into
contact with each other. Domestic water must not circulate
via the exchanger.
Service the appliance regularly to ensure that it operates correctly.
Any operation on the installation must be performed by a
qualified technician respecting professional regulations
and in accordance with this document.
Keep this document close to the place where the tank is installed.
No modifications must be made to the domestic hot water tank if the
guarantee is to remain valid.
Description
The high quality steel tank is lined with food standard quality vitrified
enamel, which protects it from corrosion and preserves all the
qualities of the domestic water.
The tank is protected against corrosion by a magnesium anode which
should be checked every 2 years and replaced if need be.
The thermal exchanger welded into the tank is made of smooth
piping, the inside of which, which is in contact with the domestic
water, is enamelled.
The calorifier is efficiently insulated with CFC-free polyurethane
foam, which reduces thermal loss to a minimum.
The insulating material can be easily detached from the tank. A
polyethylene film prevents the foam sticking to the tank. This
measure facilitates the recycling of materials.
The outside casing is made of painted steel sheeting.