5
Using your Heater
•
Use the appliance only for the mentioned purpose, namely as a heater for domestic use. Do not use it as
any other application as it could be dangerous.
•
Do not operate the heater near flammable objects (furniture, curtains, shelves etc).
•
Do not operate the heater near liquids (bath-tubs, showers, water basins, swimming pools etc).
•
Do not cover the appliance when it is operating to avoid overheating.
•
Never attempt to remove the front grille of the heater.
•
Do not put the cable on the appliance when it is still warm.
•
Do not connect the appliance to extension cords or multiple outlets.
•
Never operate the appliance immediately below an outlet.
•
Never connect the appliance to a thermal control device or a time switch to avoid
overheating risks when the radiator is moved or covered.
Caution:
This appliance gets extremely hot during operation and should be handled with care. Be careful of
getting burnt. Never put flammable objects on or near the appliance as they could set alight.
Timer operation
The timer face consists of a moveable numbered band with moveable red pins and a fixed centre plate.
When the moveable red pins are slid towards the centre plate the timer is OFF and when slid towards
the outer numbered band the timer is ON. Each red pin corresponds to 15 minutes operation. A switch
is fitted to bypass the timer if required.
•
Rotate the timer dial until the current time is opposite the pointer.
•
Slide the red pins corresponding to the required ON time towards the outer numbered band.
•
The red pins corresponding to the required OFF time are slid towards the inner band.
•
To operate under timer control, slide the bypass switch to the “O” position.
•
To bypass the timer, slide the bypass switch to the “I” position.
EXAMPLE:
Suppose it is now at 11:00PM. Rotate the
timer until “23” is opposite to the pointer
(i.e. Position A).
For operation between 8:00AM and 3:00PM,
slide the bypass switch to “O”, all the red pins
between “8” and “15”” (i.e. Area B) are slid
towards the outer band and those between “15”
and “8” are slid towards the inner band.
NOTE:
For correct timer operation the radiator must be connected to the power supply and the power switched
on. The second hand will indicate when power is connected.
Содержание DEF973987
Страница 7: ...7 1 2 3 4 5 6 ...
