PROTECTOR ELECTRONIC KEY CABINET models 40E, 80E and 120E
GENERAL
1
Each time a button is pressed the yellow light will flash
2
If the next button is not pressed within 20 seconds the system will go back to the dormant state
3
To reactivate the keypad press any button
4
The function ‘*’ (star) key and the ‘#’ hash key is the same
5
Preset factory code is 159#
6
This cabinet can have 2 user codes, a master code and a personal code
7
DO NOT KEEP THE EMERGENCY OPENING KEYS IN THE SAFE
OPENING THE SAFE FOR THE FIRST TIME
1
Gently remove the cover in the middle of the lock facia.
2
Use the emergency opening key to release the lock
3
Turn the knob to open the cabinet.
4
Insert the batteries which will be found inside the cabinet
5
Close the cabinet door, lock with the emergency keys
6
Test with the factory code – press 1, 5,9, # then turn the knob to open the door
SET A NEW MASTER CODE
1
Open the cabinet door using the factory code
2
Locate the red button (set switch) at the back of the safe door
3
Press 00 (zero, zero)
4
Press the set switch – yellow light will flash, this means the password management feature
is active
5
Input your new code – 3 – 8 digits
6
Press # or * to confirm – there will be 2 beeps and the yellow light will go off
SET A NEW PERSONAL CODE
1
Open the cabinet door
2
Press the set switch (red button) once
3
Yellow light shows password management is active
4
Input your new code – 3 – 8 digits
5
Press # or* to confirm – there will be 2 beeps and the yellow light will go off
USING THE SAFE
1
Enter the master code or the user code and press # to confirm
2
Two beeps will be hear and green light will come on
3
You now have 5 seconds to turn the knob to the right and open the door
4
After 5 seconds the green light will go off
5
If you input an incorrect code the buzzer will beep several times
6
After three incorrect code entries the system will lock for 20 seconds, after 20 seconds the
buzzer will beep for 20 seconds. When the buzzer stops try again.
