LDT- R1 User Manual
13
●
Push and hold the joystick when powering up the LDT-R1,
●
This will take you into the firmware update mode,
●
Select the firmware file from the list,
●
Press the joystick in to run the update,
●
When firmware is updated, reboot the unit by unplugging and replugging the
power cable.
For further support, contact our team at
.
Setting up the Preston MDR
The Preston MDR 3 must be running firmware 1.17 or later. Please update your MDR
3 first. In case of using MDR 2 or MDR 4 please contact DCS support for more
information and supported firmware versions.
Setup the Focus / Iris / Zoom direction for natural use on the Preston. If you are
using a separate iris handset then connect this now and ensure the direction of the
preston motors are correct. Do the same for Zoom demand.
Injection Recording
Refer to this section if you are recording data externally from the LDT-R1. This mode
is only available for digital cameras
In this chapter you can find details on how to set up a camera in order to record
metadata into the raw file headers, depending on the system you are running.
Red Camera Family
Setting up the Camera
●
First of all, make sure the camera is running firmware 7.0.2 or later,
●
Connect the RED Touch to access all of the camera settings,
