DCS Delius, Руководство пользователя, Страница: 26 / 80

dCS Delius
User Manual Manual for Software Issue 2.3x
dCS
Ltd September 2004
Manual filename: Delius Manual v2.3x.doc
Page 26
email: more@dcsltd.co.uk
English version web-site: www.dcsltd.co.uk
Swap
Swap Swap
Swap
- Swap Channels
If you have run the Channel Check test and decided the channels are reversed,
you can swap the channels back digitally as follows.
do this:
Assuming the unit is set for swap off, open the Function Menu and step through
until the display shows
Swap:Off
.
do this:
Press the
Select
button once.
The display will change to
Swap:On
.
do this:
Run through this sequence again if you want to swap back.
The
Swap
setting is
NOT
remembered when you switch off. If your channels are
swapped, check the wiring between units and correct the error.
Disp Disp Disp Disp
- Default Display
This feature allows you to choose what
Delius
displays when music is playing
do this:
Open the Function Menu and step through until you come to the
Disp
page.
Press the
Select
button repeatedly and the display will cycle through the
following :
Disp:Vol
The display reverts to Volume after time-out (e.g.
Vol -12.0
).
Disp:Fs
The display reverts to Sample Rate after time-out (e.g.
44.1kS/s
).
Disp:Fs+
The display reverts to Input Bits + Sample Rate (format)
after time-out (e.g.
24/192
). If receiving digital silence, 0
input bits will be correctly displayed.
Disp:Inp
The display reverts to the selected input after time-out
(e.g.
AES1
).
do this:
Choose whichever you prefer and wait for time-out.
Out Out Out Out
- Output Level
The Analogue Output levels should be set to suit your system – there are two
levels:
6V
(high) or
2V
(low). The difference between the two settings is 9.5dB.
For best results,
Delius’
volume control should be set to no lower than
–20.0
for
normal listening levels with typical music. We suggest you start with
2V
and
increase the level to
6V
if this is inadequate.
Before changing the output level, please ensure you are not playing music at a
high level – the extra 9.5dB is noticeably louder. To change the setting (starting
from
2V
):
do this:
Open the Function Menu and step through until the display shows
Out: 2V
.
do this:
Press the
Select
button once. The display will change to
Out: 6V
.
do this:
Run through this sequence again if you want to change back to
2V
.