DCB, Inc.
2949 CR 1000 E
Dewey, Illinois
61840
217.897.6600 Tel
800.432.2638 Toll Free
217.897.1331
www.dcbnet.com
SE-6600 Serial Encrypter Quick Start Guide
This document guides the new user through configuration of an SE-6600 serial encrypter and
demonstrates a bench setup in which a pair of devices maintain encrypted serial port
communications. Connect two PCs' serial ports through two SE-6600 units with the encrypted
link between them, as diagrammed in Figure 1 below.
Figure 1 – Configuration for End-to-End Test (IP Addresses for Setup Only)
Requirements
1. Two SE-6600 units and knowledge of basic TCP/IP networking
2. Two PCs with a wired ethernet connection, Serial Port (or USB-to-Serial adapter cable),
terminal emulation program and any modern web browser
3. LAN cable, either straight-through or crossover, to access the LAN ports (This is a
separate cable from the one provided with the SE-6600.)
4. Null modem cable, to connect the pair of SE-6600 units to each other
Step-by-Step Procedure
1:
Open the first box and note the contents: The SE-6600 serial encrypter, network cable,
“
Direct PC
” and “
Remote PC
” adapters, power supply and CDROM containing manual and
Application Notes. Power up this unit (SE-6600 “A”)
2:
Configure one of the PCs for use on the default LAN subnet of the SE-6600s. Use the IP
address 192.168.1.100 with a Subnet Mask of 255.255.255.0.
3:
Use the LAN cable to connect the PC to SE-6600 A's LAN port, open a browser (Internet
Explorer, Firefox, Chrome, Safari), and enter
(NOTE that “http” is used, not
https)
1
