DayStar Turbo 601, Руководство пользователя

Страница: 24 / 60

3
INSThLLING TH€ TURBO 601 - MhClNTOSH llw, M , PCRf^ORrhh 6 0 0
4. With the heat sink side of the Turbo 601 facing the pow er supply, align the
board’ s connector over the 120 pin accelerator slot on the motherboard.
Gently push the card dow n until it is fully seated.
Testing the installation
You have installed the Turbo 601. Make sure all connections are tight. You must
now test the installation and install the software.
Please read all o f this section b efore you test the installation.
Plug the pow er cord into the back of the Macintosh. Turn the Macintosh on.
You should hear the customary “ BONG”. If you do not hear the “ BONG”, go to
the next page.
YES! I hear the “BONG”.
1. Turn the pow er off and remove the pow er cord from the Mac.
2. Replace the case cover and screw. Attach all cables you have removed.
Now you are ready to install the software. Please go to Chapter 4, “ Installing the
Turbo 601 Software.”
NOTE: If you hear the new PowerPC bong and the M ac does not boot properly,
clear the param eter RAM by holding down the Cs-Option-P-R keys sim ultaneously
while the com puter is starting up. (Make sure the Caps Lock key is not pressed.)
Installing the Turbo 601