MOUNTING SENSOR ON THE FIXED TOP WALL OF TRASH BIN
MOUNTING SENSOR ON THE MOVABLE LID OF TRASH BIN
MOUNTING SENSOR ON THE MOVABLE LID OF TRASH BIN
MOUNTING SENSOR ON THE OPEN-STYLE TRASH BIN
The Sigfox-Ready Ultrasonic level sensor is produced with accuracy as published in the
of the product
and is ready to use. However, the user may need to configure the A & B factor to give the output as the actual level of
waste in the trash bin. The A & B factor will be calculated as the instructions in
.
Problems with Sigfox communication like not receiving the packets...please refer to
to troubleshoot
the device.
Problems with the sensor functions like not measuring or inaccurate measuring....please refer to
to
troubleshoot the sensor part.
Maintenance works
Yes/No
Descriptions
Consumable parts replacement
No
The Sigfox-Ready Ultrasonic level sensor has
no consumable parts, so there is no need to
replace any parts.
Cleaning sensor or device
Yes
As the sensor is installed in the trash bin, it is
needed to clean the device and the transducer
surface by cleaning water with a soft
detergent. Please do not use strong detergent
or chemical solvents to clean as they can
damage the transducer surface.
Re-calibration / Re-validation
Yes
The transducer may need to be re-calibrated
when necessary. Please refer to this link for
the procedure of calibration.
To get a strong RF signal, please refer to
.
1.5.3 Sensor calibration
2. Maintenance
2.1 Troubleshooting
2.2 Sensor maintenance
