DaVinci LED Power Supply
Sku# 250-04942
Page 1 of 2
17602057 - Printed 10/5/18
© Travis Industries, Inc.
Packing List
Power Supply with attached wire harness
Wire Tie
Crimp Connectors
Overview
This kit provides the parts and information needed for updating or replacing the LED power supply in a DaVinci
fireplace. This power supply will be a smaller and quieter replacement for the older power supplies or a direct
replacement for newer units.
Disconnect gas and power to the fireplace before proceeding.
Make sure the fireplace has fully cooled prior to conducting service.
Installation (Fireplaces W/O TouchSmart Controllers)
1. Gain access to the component area of the fireplace (see installation manual for details).
2. Locate the LED power supply. Disconnect the Molex connector from the “power in” on the fireplace.
Disconnect the wires marked “LED XFMR” from the terminals on the power supply. You may discard the
power supply and harness.
3. Install the replacement power supply into the location of the previous power supply. The power supply
should be oriented so the label is facing upward. Secure the power supply in place using the included
wire tie.
Disconnect LED
XFMR wires
Disconnect
“Power In”
Label should be
facing upward
