7
DAVCO Technology, LLC
www.davco.com
800-328-2611
1600 Woodland Drive, Saline, MI 48176-1629
F1321 REV E
SHOP PRO
®
ST
WITH 50/80 PSI PRESSURE REGULATOR
TECHNICAL MANUAL
PRIMING THE FUEL MODULE WITH COMPUCHECK FITTING
Regulator Settings:
Use the 80 PSI Regulator setting to prime the fuel module .
1 . Connect the Shop Pro to a power source .
2 . Attach the Pick-up (60") wand to the suction hose (green)
and insert it into the fuel tank .
3 . Open the ball valve .
4 . Attach the Compucheck Adapter (blue hose) to the
pressure hose (red) on the Shop Pro .
5 . Connect the Compucheck fitting to the priming port on
the fuel module .
6 . Open the ball valve .
7 . Turn the Shop Pro FXP ON . Prime the fuel system for four
minutes .
8 . While the Shop Pro is still turned ON, start the engine .
Allow the engine to idle for one minute before revving the
engine . Turn off the engine .
9 . Turn the Shop Pro off . Close the Shop Pro pressure hose
ball valve . Remove the Compucheck adapter from the fuel
module .
10 . Remove the pick-up wand from the fuel tank . Allow the
fuel to drain back into the tank before closing the ball
valve .
11 . Return the adapters and hoses to the Shop Pro cart .
12 . Restart the truck and check for leaks .
