Datex-Ohmeda S/5 M-P, Техническое описание слота

Страница: 29 / 42

Pressure Module, M-P and Pressure Temp Module, M-PT
Document No. 800 1013-1
25
5.1 P/PT menu
Calibrations See section 5.2 “ Calibrations menu .”
Record Data Record Data prints out the shown service data and board information (id., serial number, and
software id.) onto the recorder module, M-REC.
Service Data
Gain is a coefficient to compensate gain error. Usually the value for P3 is between 17000 and
25000 and for T3 and T4 between 13000 and 14300. Zero indicates offset compensation value
of each parameter in A/D converter. Typically the values for P3 is within
±
1000 and for T3 and T4
between -150 and +300. Calibrate if zero and/or gain value is outside the ranges.
Cable shows ON when the corresponding cable is connected to the front panel and Probe shows
ON when the corresponding probe is connected to the cable.
Under
Value the measured numeric values are displayed simultaneously. Pressure value is a real
time value and shown in mmHg.
Button ; the front panel key function can be confirmed by pressing the key and checking that OFF
turns to ON.
Temp error shows whether the calibration of the temperature was successful or not.
Protect key shows normally OFF but turns to ON when the button at the bottom of the module is
pressed.
Protect mode is normally ON. It turns to OFF when Protect is switched to OFF for the temperature
calibration in Calibration Menu.
Configuration shows the chosen module configuration: BP or PT.
Timeouts is a cumulative number that indicates how many times the module has not responded to
the monitor's inquiry.
Bad checksums is also a cumulative number that indicates how many times communication from
the module to monitor broke down.
Bad c-s by mod is a cumulative number that indicates how many communication errors the
module has detected.
The monitor starts counting these items at power up and resets to zero at power off. The nonzero