Datex-Ohmeda S/5 Compact Anesthesia Monitor, Техническое справочное руководство

Страница: 58 / 72

Datex-Ohmeda S/5 Compact Anesthesia and Critical Care Monitor
5.3.22 Entropy Module, M-ENTROPY
1. Check the function of the front panel membrane keys.
2. Connect the Entropy sensor cable and Entropy simulator to the module. See that “Checking
sensor” text and image appear to the waveform numeric field. Wait for a while and check that
all sensors show “PASS” .
3. Check that the EntrEEG waveform and RE and SE values appear on the monitor screen.
"
5.3.23 Interface Board/Module, B-INT/M-INT
1. Make sure that the monitor receives all necessary parameter data from the connected
devices. Check the screen configuration and the related interfacing settings, if necessary.
Monitor Setup – Interfacing
"
5.3.24 Device Interfacing Solution, N-DISxxx
1. Make sure that the monitor receives all necessary parameter data from the connected
devices. Check the screen configuration and the related interfacing settings, if necessary.
Monitor Setup
- Interfacing - Staus Page
"
5.3.25 General
1. Perform an Electrical safety check and a leakage current test.
Check that the monitor and all connected units function normally after the performed test
2. Switch the monitor to standby and perform final cleaning.
Fill in all necessary documents.
"
Document No. M1031508
48