Datawell BV RX-C4, Руководство пользователя

Страница: 21 / 49

21
By clicking on the “map” link, the buoy position is plotted on a map. The map function will
only work when the computer from which the web interface is accessed has an internet
connection.
4.3.1 Web interface settings page
The settings page is protected by a username and password to prevent unauthorized access to
the RX-C4 settings. The login user name is “
rxc ” and the default password is “ waverider ”.
Figure 4.9 shows the web interface settings page.
Figure 4.9. RX-C4 web interface settings page.
Changing the reception frequency
The reception frequency is changed by entering the new frequency on the settings page and
clicking “apply”. The new frequency must be entered in MHz and must be within the limits of
the receiver specifications. The receiver statistics on the web interface home page can be used to
check if the receiver is correctly receiving data on the new frequency.
Changing the receiver mode
The receiver mode is changed by choosing the new mode from the pull down menu and clicking
“apply”. The receiver statistics on the web interface home page can be used to check if the
receiver is correctly receiving data in the new mode. For more information about the receiver
mode, refer to
paragraph 4.1.3 .
Changing the password
The default password is changed to a new password by entering the new password on the
settings page and clicking “apply”. The new password must be between 3 and 15 characters in
length. For security reasons, it is strongly recommended to change the default password. The
login user name is fixed and cannot be changed.
It is possible to reset the password to the default password in case the password is forgotten.
This can only be done from the network menu as described in
paragraph 4.1.4 .
Restarting the receiver
The receiver can be remotely reset by clicking on the “reset” button. It should not be necessary
to use this function during normal operation. After reset, it is possible that the web interface
does not reload properly. To reload the web interface, re-enter the web interface address in the
address bar of the web browser.