Datavideo WM-10, Инструкция по эксплуатации, Страница: 17 / 20

16
SAFETY NOTES
- Before beginning the installation, it is very important to examine the unit for damage, defects and
correct hardware.
- The installation instructions must be read and entirely understood prior to install.
- It must be determined that the mounting surface is capable of supporting the mount and equipment.
- The professional installer must determine the proper way to attach the WALL BRACKET MODEL XXXX
- The installation of the mount and equipment is dependent on proper/secure attachment and is the
responsibility of the installer.
- Make sure wall will support 4 times the combined weight of Equipment and Wall Mount.
- This mount should be attached to wood studs only. Under no circumstances should this product be
mounted to metal studs, unless an installation professional deems they have been adequately
reinforced and will support 4 times the combined weight of Equipment and Wall Mount.
- Please use only the bolts supplied with the unit or bolts of the correct size, making sure the hardware
used is tightened properly for a secure installation.
- The WALL BRACKET MODEL is only intended to be used with the equipment listed on the install
sheet. It is not meant to be used with any other equipment.
- If at anytime, a question arises regarding this installation (or regarding the safety or integrity of the
projected use), please cease the installation and either obtain the advice of another qualified
installer or contact FEC.
Weight
Weight of the WM-10
3.95 Kg = 8.70 lb
Maximum Load Weight Limit
10Kg
* Please note that the WM-10 wall mount kit can be applied to the PTR-10/PTR-10T and PTC-150 series.