ENG & FREESTANDING TELEPROMPTER KIT TP-700
20
Camera Exposure and the 70/30 Mirror Glass
After setting up the camera with the 70/30 glass in front of the lens adjust the camera set up and white balance. This is
because the 70/30 Glass affects the camera exposure by approximately 1 stop almost like the effect of a neutral density
filter. Consult your camera manual for further help and advice with its exposure and white balance settings.
Cleaning the 70/30 Glass
This product contains a sheet of 70/30 glass please handle it with care.
To avoid a risk of damage or injury please follow this instruction manual and use caution
when transporting, un-packing, cleaning, assembling or dis-assembling this part of the
product.
Datavideo recommend cleaning the glass regularly to remove dust and finger print marks.
This will ensure the best image quality is recorded when the camera is looking through the glass.
Never attempt to clean the glass whilst it is mounted in the prompter
instead remove it carefully from the
prompter, clean the glass and then re-install it into the prompter frame. Handle the glass carefully using the
cloth covered edges of the glass at all times.
To retain the required qualities of the glass and to avoid scratching the glass during cleaning.
Never use
abrasive cloths, pads or abrasive based cleaning fluids on the glass.
Never use
cleaning fluids based on an acid or vinegar solution.
Place the glass on a soft, stable, dirt and lint free work
surface such as a table with a clean cloth already laid out
on it. Then use a second clean, lint free, soft cloth to clean
the glass.
Do not apply cleaning fluids to the glass directly, instead
apply or spray a small amount of the cleaning fluid onto
the cloth. Proceed to clean the glass and work in a light
circular motion with the cloth. Ensure all finger marks and streaks are gone before turning the glass over and
repeating with the other side.
