DDR-16/32 Installation and Operating Guide
Page 11
DDR-16/32 Installation & Operating Guide
Document # 9301H85300 Ver. 0.91
1.3 Powering ON the DDR-16/32
The main power switch for the DDR-16/32 is located on the rear panel. A “hard boot” (cycling the
power at the power entry module on the rear panel). When the main power switch is on, the DDR-16/32
can be switched in and out of standby power mode using the pushbutton power switch on the front panel.
1.4 Front Panel Controls
Figure 1: Front Panel Controls
The front panel contains the following controls:
1.
Power button/indicator
: Push button switch puts the DDR-16/32 in and out of standby power
mode.
2.
ON and STANDBY LEDs
: Upon switching the rear panel main power switch to On, the
orange Standby LED begins to blink, indicating system is booting. When booting has
successfully completed, orange LED goes solid. Pressing the front panel (Standby) Power
Button extinguishes the standby LED and the blue On LED will light. Pressing Power Button
once again returns the unit to the Standby state with orange LED on.
1.5 Rear Panel Controls / Connections
Figure 2. DDR-16/32 Rear Panel
Table 1 gives a description of each connector shown in the figure. For specific information on the pin-
outs of each connector, please see Appendix A of this manual.
